• Latest POSTS

    Automobile Engineering - Set 12

    Practice Test: Question Set - 12

    1. The materials used for cylinder block are
      (A) Cast iron and steel
      (B) Cast iron and aluminium alloy
      (C) Steel and aluminium alloy
      (D) Brass and steel

    2. The included angle is the sum of the
      (A) Camber and castor
      (B) Castor and S.A.I.
      (C) Camber and S.A.I.
      (D) Camber and toe in

    3. Vulcanizing means
      (A) Heating rubber under pressure
      (B) Spraying with special paint
      (C) Melting rubber while stirring it
      (D) None of these

    4. The material generally used for cylinder sleeves is
      (A) Aluminium
      (B) Ceramic
      (C) Cast iron
      (D) Fibre reinforced plastic

    5. When turning a corner
      (A) The front wheels are toeing out
      (B) The front wheels are turning on different angles
      (C) The inside front wheels has a greater angle than the outside wheel
      (D) All of the above

    6. The rolling resistance is because of the friction between the
      (A) Wheel rim and tyre
      (B) Tyre and the road surface
      (C) Wheel rim and road surface
      (D) None of these

    7. When a gear box has four forward speeds and one reverse speed, it is said to be a
      (A) 3-speed gear box
      (B) 4-speed gear box
      (C) 5-speed gear box
      (D) 6-speed gear box

    8. The basic purpose of providing caster angle on wheels is to
      (A) Prevent uneven tyre wear
      (B) Maintain directional control
      (C) Bring the road contact of the tyre under the point of load
      (D) Compensate for wear in the steering linkage

    9. When the piston is at T.D.C., the volume above the piston in the combustion chamber is the
      (A) Clearance volume
      (B) Cylinder volume
      (C) Exhaust volume
      (D) None of these

    10. In a hydraulic power steering system, the power steering pump is driven by a
      (A) Belt driven by camshaft
      (B) Chain driven by crankshaft
      (C) Belt driven by drive-shaft
      (D) Belt driven by crankshaft

    11. The correct way to rectify an imbalanced wheel is to
      (A) Adjust the tyre pressure
      (B) Rotate the tyres
      (C) Adjust the damper spring tension
      (D) Attach appropriate weights to the wheel at appropriate positions

    12. The fuel that detonates easily, is
      (A) N-heptane
      (B) Iso-octane
      (C) Benzene
      (D) Alcohol

    13. The Diesel engine works on
      (A) Otto cycle
      (B) Carnot cycle
      (C) Diesel cycle
      (D) Rankine cycle

    14. The parking brake generally acts on
      (A) Front wheels
      (B) Rear wheels
      (C) Front and rear wheels
      (D) Propeller shaft

    15. The forced fed lubrication system means that the oil is delivered to the engine by
      (A) Gravity
      (B) The pressure created by the oil pump
      (C) Splashing action of the crankshaft
      (D) None of these

    Show and hide multiple DIV using JavaScript View All Answers

    • Blogger Comments
    • Facebook Comments

    Post a Comment

    Item Reviewed: Automobile Engineering - Set 12 Rating: 5 Reviewed By: Pranab Debnath
    Scroll to Top