Production Engineering MCQ Online Practice Test - Set 23

Practice Test: Question Set - 23


1. A single point tool has
    (A) Rake angle
    (B) Cutting angle
    (C) Lip angle
    (D) All of these

2. When the tool moves parallel to the lathe axis, the movement is termed as
    (A) Cross feed
    (B) Angular feed
    (C) Longitudinal feed
    (D) Any one of these

3. The grade of grinding wheel depends upon
    (A) Hardness of the material being ground
    (B) Speed of wheel and work
    (C) Condition of grinding machine
    (D) All of these

4. In electro discharge machining, tool is made of
    (A) Brass
    (B) Copper
    (C) Copper tungsten alloy
    (D) All of these

5. Tool life is generally better when
    (A) Grain size of the metal is large
    (B) Grain size of the metal is small
    (C) Hard constituents are present in the micro-structure of the tool material
    (D) None of the above

6. The cutting angle of a flat drill varies from
    (A) 3° to 8°
    (B) 20° to 30°
    (C) 60° to 90°
    (D) 90° to 120°

7. Discontinuous chips are formed during machining of
    (A) Brittle metals
    (B) Ductile metals
    (C) Hard metals
    (D) Soft metals

8. As the cutting speed increases, the tool cutting forces
    (A) Remain constant
    (B) Increases
    (C) Decreases
    (D) First increases and then decreases

9. Soft materials can not be economically ground due to
    (A) High temperature involved
    (B) Frequent wheel clogging
    (C) Rapid wheel wear
    (D) Low work piece stiffness

10. In which of the following machine, the work is usually rotated while the drill is fed into work?
    (A) Sensitive drilling machine
    (B) Radial drilling machine
    (C) Gang drilling machine
    (D) Deep hole drilling machine

11. For harder alloy steel, the point angle of the drill is kept
    (A) Equal to 118°
    (B) Less than 118°
    (C) More than 118°
    (D) Any one of these

12. The average cutting speed for turning mild steel with a high speed steel tool is
    (A) 15 to 19 m/min
    (B) 25 to 31 m/min
    (C) 60 to 90 m/min
    (D) 90 to 120 m/min

13. The taper on the lathe spindle is
    (A) 1 in 10
    (B) 1 in 15
    (C) 1 in 20
    (D) 1 in 30

14. In drilling softer materials, the cutting speed is ___________ as compared to harder materials.
    (A) Same
    (B) Low
    (C) High
    (D) None of these

15. Internal or external threads of different pitches can be produced by
    (A) Pantograph milling machine
    (B) Profiling machine
    (C) Planetary milling machine
    (D) Piano miller

Show and hide multiple DIV using JavaScript View All Answers


Manufacturing and Production Technology:
  Set 01      Set 02      Set 03      Set 04      Set 05      Set 06      Set 07      Set 08      Set 09
  Set 10      Set 11      Set 12      Set 13      Set 14      Set 15      Set 16      Set 17      Set 18
  Set 19      Set 20      Set 21      Set 22      Set 23      Set 24      Set 25      Set 26      Set 27
  Set 28
Share on Google Plus

    FB Comments
    Comments

0 comments:

Post a Comment