MCQ Practice on Engineering Drawing - Set 07

Practice Test: Question Set - 07

1. This type of solid is egg-shaped and can be created by revolving an ellipse around one of its axes:
    (A) Ellipsoid
    (B) Torus
    (C) Cone
    (D) Cylinder

2. This type of circuit is a semiconductor wafer or chip:
    (A) Integrated circuit
    (B) Transmission circuit
    (C) Plotted circuit
    (D) Conducted circuit

3. Isometric drawings are often used by ________ to help illustrate complex designs.
    (A) Mechanical engineers
    (B) Piping drafters
    (C) Aerospace engineers
    (D) All of the above

4. In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:
    (A) One inch or over
    (B) One foot or over
    (C) One yard or over
    (D) One rod or over

5. The principle views associated with orthographic projection are ________.
    (A) Front view
    (B) Right side view
    (C) Top view
    (D) All of the above

6. This is formed where three or more surfaces intersect:
    (A) Oblique
    (B) Line
    (C) Edge
    (D) Vertex

7. On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
    (A) Transmission diagrams
    (B) Operating relays
    (C) Closed relays
    (D) Terminal circles

8. A round is a rounded surface on the ________ corner of a part.
    (A) Inside
    (B) Outside
    (C) Radial
    (D) Isoplane

9. In this type of dimensioning, allowance must be made for bends:
    (A) Angular
    (B) Tolerance
    (C) Datum
    (D) Sheet metal

10. A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
    (A) Architectural
    (B) Civil
    (C) Mechanical
    (D) Process piping

11. Three dimensional models are often used in the design process to ________.
    (A) Help the client understand the overall design concept
    (B) Help the client select a color for their carpet
    (C) Provide the client with a model which they can use to impress their friends
    (D) Determine the quantity of brick needed to build the house

12. Schematic and single-line diagrams should be arranged so that signal or transmission path from input to output proceeds in this fashion:
    (A) Right to left and top to bottom
    (B) Right to left and bottom to top
    (C) Left to right and top to bottom
    (D) Left to right and bottom to top

13. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
    (A) Use the Modify tool to clean up the extension lines
    (B) Use the Tolerance tool to clean up the extension lines
    (C) Use the Break tool to clean up the extension lines
    (D) Use the stretch tool to clean up the extension lines

14. These types of projectors converge at a vanishing point:
    (A) Perspective
    (B) Parallel
    (C) Orthographic
    (D) Oblique

15. These items typically are not used in new designs, but are still common in high-power amplifiers:
    (A) Amplifier tubes
    (B) Electron tubes
    (C) Signal relays
    (D) Switches

Show and hide multiple DIV using JavaScript View All Answers

Mechanical Engineering Drawing:
  Set 01      Set 02      Set 03      Set 04      Set 05      Set 06      Set 07      Set 08      Set 09
  Set 10      Set 11      Set 12      Set 13      Set 14      Set 15      Set 16      Set 17
Share on Google Plus

    FB Comments


Post a Comment