Practice Test: Question Set - 01
1. The 34-pin connection on an I/O card is for?
- (A) Floppy drive
- (B) SCSI drive
- (C) IDE drive
- (D) Zip drive
2. Which would you have to upgrade to install an EIDE drive?
- (A) RAM BIOS
- (B) A 286 CPU
- (C) Controller
board
- (D) ISA
motherboard
3. COM1 is typically represented by which of the following?
- (A) 15 pin port
- (B) 9 pin male
port
- (C) 9 pin female
port
- (D) 25 pin male
port
4. How can you totally protect a PC from damage during an electrical storm?
- (A) Disconnect
the AC power cable
- (B) Disconnect
all external cables and power cords
- (C) Use a surge
protector
- (D) Turn off the
AC power
5. You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
- (A) As
a master
- (B) As
a secondary
- (C) As
a slave
- (D) As
a primary
6. What would you ask to determine if the display is working?
- (A) Is
there a video cursor or action on the screen
- (B) Did
the computer beep or chime
- (C) Is there
high voltage static on the screen
- (D) All
of the above
7. You can place an ISA device in an EISA slot.
- (A) True
- (B) False
8. How is ink transferred to paper in common ink jet printers?
- (A) Boiling ink
- (B) Crystal
- (C) Motorized
pump
- (D) Screens
deflect ink on the paper into the proper positions
9. Type one PC cards:
- (A) Are
used only in desktops
- (B) Are
no longer being produced
- (C) Are
the thinnest of the PC cards
- (D) Don’t
exist
10. After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:
- (A) System's
floppy drive device driver
- (B) Original
IDE controller
- (C) Floppy
drive ribbon cable
- (D) System's
power supply
11. The DC voltage on most circuit boards is:
- (A) -12 volts
- (B) 0 volts
- (C) +5 volts
- (D) +12 volts
12. Suppose that the power lamp in on, but the printer will not print. What can you do to correct the problem?
- (A) Make
sure the printer is on line
- (B) Replace
the AC line fuse
- (C) Turn the
printer on and off
- (D) Replace
the ribbon
13. Resistance is measured:
- (A) In parallel
- (B) In
series
- (C) After
breaking the circuit
- (D) After
checking voltage
14. What voltage does a 586 system use?
- (A) +12 volts
- (B) + 5 volts
- (C) + 8
volts
- (D) +3.3
volts
15. What can you use to ensure power is not interrupted, resulting in corrupted data?
- (A) UPS
- (B) Proper
grounding
- (C) Surge
protector
- (D) Sag
protector
Next Tests:
Blogger Comment
Facebook Comment