Today, all competitive exams are Multiple Choice Questions(MCQ) based examination system and the main factor is to answer each question in a prescribed time. So, practice as much as possible before the original test you are going to face.
Total number of Multiple Choice Question (MCQ) is 15 and time allotted for each question is 30 seconds. After the allotted time, the question will be marked as un-attempt.
QUIZ
Test Conducted by: ObjectiveBooks.com
Next Mock Tests:
01. Softer variety of steel may be obtained by
(A) Cementation process
(B) Crucible process
(C) Bessemer process
(D) Open hearth process
Answer: Option C
02. For interpolation of satellite data used for monitoring dynamic changes that occurs on the earth surface, the most suitable orbit for the satellite is:
(A) Circular orbit
(B) Sun-synchronous orbit
(C) Near polar orbit
(D) None of these
Answer: Option B
03. The angle subtended by the surface of sewer water with partial flow, at sewer centre is 120°, the depth of sewerage is
(A) 20 cm
(B) 25 cm
(C) 40 cm
(D) 50 cm
Answer: Option D
04. For a given material, if E, C, K and m are Young's modulus, shearing modulus, bulk modulus and Poisson ratio, the following relation does not hold good
(A) E = 9KC/3K + C
(B) E = 2K (1 + 2/m)
(C) E = 2C (1 + 1/m)
(D) E = 3C (1 - 1/m)
Answer: Option C
05. The most commonly adopted method to provide super-elevation on roads, is by pivoting the road surface about
(A) Outer edge so that the inner edge is lowered
(B) Crown so that outer edge is raised and inner edge is lowered
(C) Inner edge so that outer edge is raised
(D) None of these
Answer: Option C
06. Valid range for n, the percentage voids, is
(A) 0 < n < 100
(B) 0 ≤ n ≤ 100
(C) n > 0
(D) n < 0
Answer: Option A
07. In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as
(A) Sum of thickness of both leaves
(B) Two-third of the sum of thickness of both the leaves
(C) Actual thickness of the stronger leaf
(D) Larger of (B) and (C)
Answer: Option D
08. Rolled steel beams are:
(A) Mainly used to resist bending stress
(B) Used as independent sections to resist compressive stress
(C) Used as independent sections to resist tensile stress
(D) All the above
Answer: Option D
09. Shoulders for high traffic volume roads, should
(A) Be stable throughout the year to be used by vehicles in the case of emergency
(B) Support and protect the ends of carriage ways
(C) Not allow entrance of water to sub-grade
(D) All the above
Answer: Option D
10. The whole circle bearing of a line is 290°. Its reduced bearing is
(A) N 20° E
(B) N 20° W
(C) N 70° W
(D) S 70° E
Answer: Option C
11. Regime conditions in a channel may occur if
(A) Discharge is constant
(B) Channel flows uniformly in incoherent alluvium as that transported in suspension
(C) Silt grade and silt charge are constant
(D) All the above
Answer: Option D
12. Rails are bent to correct curvature if the degree of curve, is more than
(A) 1°
(B) 2°
(C) 3°
(D) 4°
Answer: Option D
13. Pick up the correct statement from the following:
(A) Melamine is obtained from calcium carbide
(B) Formaldehyde is prepared synthetically from methane
(C) The melamine when reacted with formaldehyde forms the melamine-formaldehyde resin
(D) All the above
Answer: Option D
14. In case of a double line river, contours are
(A) Stopped at the banks of the river
(B) Stopped at the edge of the river
(C) Drawn across the water
(D) Drawn by parabolic curves having their vertex at the centre of the water
Answer: Option B
15. The portion of the brick cut across its width and having its length equal to that of a full brick, is known as
(A) Closer
(B) Queen closer
(C) King closer
(D) Prince closer
Answer: Option B
