Practice Test: Question Set - 02
1. What is the purpose of using lubricant?
- (A) Increase
wear
- (B) Increase
adhesion
- (C) Reduce
friction
- (D) Increase
corrosion rate
2. What is used to test the flatness of lathe bed?
- (A) Straight
edge and gauge blocks
- (B) Test mandrel
- (C) Spirit level
- (D) Plumb bob
3. What is measured from start time taken to end of machining a job?
- (A) Machine
cycle time
- (B) Overall
cycle time
- (C) Cycle time
- (D) Production
cycle time
4. What keeps the vital parts in condition to increase the life of machine?
- (A) Lubrication
- (B) Coolant
- (C) Dry
- (D) Water
5. What is the full form of TPM?
- (A) Total
Productive Management
- (B) Total
Process Planning Management
- (C) Total
Productive Maintenance
- (D) Total Planned
Maintenance
6. Which document instructs the work team to take up the production work?
- (A) Maintenance
card
- (B) Job card
- (C) Bill of
material
- (D) Work
activity log
7. Which type of maintenance involves daily cleaning inspection, oiling and re-tightening?
- (A) Breakdown
- (B) Preventive
- (C) Predictive
- (D) Periodic
8. Which type of maintenance involves, if a machine until it completely breaks down?
- (A) Preventive
maintenance
- (B) Predictive maintenance
- (C) Corrective
maintenance
- (D) Breakdown
maintenance
9. Which instrument tests the run-out of wheel spindle nose in surface grinding?
- (A) Dial test
indicator
- (B) Straight
edge
- (C) Mandrel
- (D) Sprit level
10. Which is the property of lubricant that gives off vapor at lowest temperature on heating?
- (A) Viscosity
- (B) Fire point
- (C) Flash point
- (D) Pour point
11. Which property refers to a combination of wettability, surface tension and slipperiness?
- (A) Viscosity
- (B) Oiliness
- (C) Flash point
- (D) Fire point
Next Tests:
Blogger Comment
Facebook Comment