Practice Test: Question Set - 01
1. Which one of the following parts of a universal surface gauge helps to draw parallel lines along a datum edge?
- (A) Fine
adjusting screw
- (B) Guide pins
- (C) Base
- (D) Rocker arm
2. A divider is used for
- (A) Scribing
circles
- (B) Scribing
arcs
- (C) Transferring
and stepping of distances
- (D) All of the
above
3. Which type of rule is used for marking and measuring patterns and hot jobs handled by blacksmith?
- (A) Narrow rule
- (B) Shrink rule
- (C) Hook rule
- (D) Short rule
4. The point angle of centre punch is
- (A) 30°
- (B) 60°
- (C) 90°
- (D) 120°
5. The slots are provided on angle plate for
- (A) Accommodation
bolts
- (B) Hanging with
hooks
- (C) Reducing
weight
- (D) Aligning the
work
6. The point angle of Scriber is
- (A) 30°
- (B) 60°
- (C) 5° to 10°
- (D) 12° to 15°
7. Scriber is made of
- (A) Copper
- (B) High carbon
steel
- (C) Mild steel
- (D) Cast iron
8. Which of the following is not the part of a combination set?
- (A) Stock
- (B) Protractor
head
- (C) Square head
- (D) Centre head
9. 'V' blocks are available in grades of
- (A) 0 and 1
- (B) 1 and 2
- (C) A1 and A2
- (D) 0 and 1 also
1 and 2
10. 'V' block is used to hold round bars. It has a Vee groove which is usually
- (A) 30°
- (B) 60°
- (C) 90°
- (D) 120°
11. Which head is used and set to any required angle in the combination set?
- (A) Square head
- (B) Protractor
head
- (C) Centre head
- (D) Rule
12. The tool which is used for laying out large circles is
- (A) Trammel
- (B) Divider
- (C) Jenny
caliper
- (D) Scriber
13. During Marking, the reference surface is provided by
- (A) Sketch of
the job
- (B) Workpiece
- (C) Marking off
table surface
- (D) Surface
gauge
Blogger Comment
Facebook Comment