Practice Test: Question Set - 01
1. Which of the following material is commonly used for making locating & locking device?
- (A) Low Carbon
Steel
- (B) High Carbon
Steel
- (C) High Speed
Steel
- (D) Gun Metal
2. Which chuck is push out & drawing type chuck?
- (A) Collet chuck
- (B) Hydraulic
chuck
- (C) Combination
chuck
- (D) Magnetic
chuck
3. Which is not a clamp from the followings?
- (A) Finger
- (B) Offset
- (C) Straight
- (D) T-bolt
4. Which is not the basic feature of drill jig?
- (A) Base plate
- (B) Jig body
- (C) Drill Plate
- (D) Screw sack
5. Which of the following is not the function of a jig?
- (A) Holding
- (B) Locating
- (C) Finishing
- (D) Guiding
6. Which device is used to hold the work piece securely in a jig or fixture against the cutting force?
- (A) Clamping
device
- (B) Locating
device
- (C) Guide device
- (D) Indexing
device
7. Which of the following can be hold by three jaw chuck?
- (A) Rectangle
work
- (B) Hexagonal
work
- (C) Pentagonal
work
- (D) Square work
8. In which of the following machine, Fixture is not used?
- (A) Shaping
machine
- (B) Milling
machine
- (C) Turning
machine
- (D) Fitting
machine
9. Which process is not used to construct jig & fixtures?
- (A) Casting
- (B) Fabrication
- (C) Welding
- (D) Turning
10. How many types of a drill bush?
- (A) 3
- (B) 2
- (C) 1
- (D) 4
11. Which jig has no base plate?
- (A) Box jig
- (B) Post jig
- (C) Latch jig
- (D) Plate jig
12. Which of the following is not a part of four jaw chuck?
- (A) Back plate
- (B) Dead center
- (C) Body
- (D) Jaws
13. Why is vice clamp used?
- (A) To prevent
surface finish
- (B) To hold the
job strongly
- (C) To prevent a
hard job
- (D) To prevent
movable job against file
14. Which of the following operation jigs are not used?
- (A) Milling
- (B) Drilling
- (C) Reaming
- (D) Taping
Next Tests: