Practice Test: Question Set - 03
1. Which is used to convert rotary into reciprocating motion?
- (A) Cam Shaft
- (B) Connecting
rod
- (C) Rocker arm
- (D) Main shaft
2. What is the material used to produce crank shaft?
- (A) Chromium
vanadium nickel steel
- (B) High speed
steel
- (C) Cast iron
- (D) Wrought iron
3. Where the fly wheel is fitted in the engine?
- (A) Cam shaft
- (B) Crank shaft
- (C) Rocker arm
shaft
- (D) Primary
shaft
4. Which instrument is used to check the tappet clearance?
- (A) Depth gauge
- (B) Pitch gauge
- (C) Feeler gauge
- (D) Wire gauge
5. Which is transferring energy for the piston to crankshaft?
- (A) Gudgeon pin
- (B) King pin
- (C) Connecting
rod
- (D) Cam shaft
6. Which load taken by the roller bearing?
- (A) Radial load
- (B) Axial load
- (C) Thrust load
- (D) Radial and
axial load
7. Which is the drive source of a cam shaft?
- (A) Crank Shaft
- (B) Fly wheel
- (C) Self motor
- (D) Gear box
8. Which part connects the piston with crank pin?
- (A) Push rod
- (B) Connecting
rod
- (C) Cam Shaft
- (D) Crank Shaft
9. Where the bush bearing preferred?
- (A) Connecting
rods
- (B) Fly wheel
and water pumps
- (C) Differential
and wheel hub
- (D) Gear boxes
10. What is the material of inlet valve?
- (A) Nickel steel
alloy
- (B) Aluminium
alloy
- (C) Copper alloy
- (D) Chromium
alloy
11. Which tool used to remove the crank shaft pulley?
- (A) Double end
spanner
- (B) Ring spanner
- (C) Pipe wrench
- (D) Puller
12. What is the purpose of the fly wheel timing mark?
- (A) To coincide
the gears
- (B) To set the
engine timing
- (C) To set the
F.I.P timing
- (D) To set the
valve clearance
13. Which instrument is used to check the leakage of the cylinder?
- (A) Compression
gauge
- (B) Dial gauge
- (C) Vacuum gauge
- (D) Wire gauge
Next Tests: