Practice Test: Question Set - 01
1. Which instrument is used to measure the diameter of cam shaft journals?
- (A) Depth
micrometer
- (B) Three-point
internal micrometer
- (C) Inside
micrometer
- (D) Outside
micrometer
2. Which instrument used to read the telescopic gauge measurement?
- (A) Depth
micrometer
- (B) Inside
micrometer
- (C) Outside
micrometer
- (D) Three
point internal micrometer
3. Which marking media used to mark in the finished surfaces?
- (A) White wash
- (B) Prussian
blue
- (C) Copper
Sulphate
- (D) Cellulose
lacquer
4. Which instrument is used to check the right angle?
- (A) Steel rule
- (B) Try square
- (C) Firm joint
caliper
- (D) Spring Joint
caliper
5. What is the least count of vernier caliper in metric system?
- (A) 0.1 mm
- (B) 0.01 mm
- (C) 0.02 mm
- (D) 0.001 mm
6. Which instrument not used to check inside size of slots?
- (A) Vernier
caliper
- (B) Outside
micrometer
- (C) Inside
micrometer
- (D) Telescopic
gauge
7. Which type of chisel used for squaring material at the corners?
- (A) Flat chisel
- (B) Half round
chisel
- (C) Cross cut
chisel
- (D) Diamond
point chisel
8. Which screw driver is used in the space limitation?
- (A) Cross-recess
screwdriver
- (B) Ratchet
screw driver
- (C) Stumpy screw
driver
- (D) Offset screw
driver
9. What is the least count of the metric outside micrometer?
- (A) 0.01 mm
- (B) 0.10 mm
- (C) 0.0001 mm
- (D) 0.00001 mm
10. How many equal thimble divisions are made in outside micrometer?
- (A) 30 Divisions
- (B) 40 Divisions
- (C) 50 Divisions
- (D) 60 Divisions
11. Which marking media is poisonous?
- (A) White wash
- (B) Prussian
blue
- (C) Copper
sulphate
- (D) Cellulose
lacquer
12. What is the angle of prick punch?
- (A) 60°
- (B) 90°
- (C) 120°
- (D) 180°
13. Which part of vernier caliper used to measure internal and external measurement?
- (A) Beam
- (B) Sliding unit
- (C) Fixed jaw
- (D) Movable jaw
Next Tests:
Blogger Comment
Facebook Comment