Practice Test: Question Set - 02
1. What is the Purpose of chisel?
- (A) Grinding
- (B) Machining
- (C) Reaming
- (D) Chipping
2. Which condition the tyre pressure not to be checked?
- (A) Tyre is cold
- (B) Tyre is
carrying load
- (C) Before start
of journey
- (D) Tyre is hot
after long run
3. What is the point angle of centre punch?
- (A) 30°
- (B) 45°
- (C) 60°
- (D) 90°
4. Which measuring instrument used to measuring inside, outside and depth of work piece?
- (A) Steel rule
- (B) Micrometer
- (C) Dial caliper
- (D) Vernier
caliper
5. Which chisel is used to remove metal from large flat surface?
- (A) Flat chisel
- (B) Cross cut
chisel
- (C) Half round
nose chisel
- (D) Diamond
point chisel
6. Which part ensures uniform pressure on the measuring faces in the outside micrometer?
- (A) Barrel
- (B) Spindle
- (C) Thimble
- (D) Ratchet stop
7. Which instrument is used to check the end-play of crank shaft?
- (A) Dial test
indicator
- (B) Telescopic
gauge
- (C) Bore dial
gauge
- (D) Slip gauge
8. Which marking device used to scribe circle?
- (A) Jenny
caliper
- (B) Inside
caliper
- (C) Spring
divider
- (D) Outside
caliper
9. What is the smallest possible measurement that can be taken with the depth micrometer?
- (A) 0.01 mm
- (B) 0.02 mm
- (C) 0.001 mm
- (D) 0.002 mm
10. What is the purpose of the eye hole in a hammer?
- (A) Strike the
job
- (B) Fix the
handle
- (C) Reduce the
weight
- (D) Stamp the
details
11. Which is the fixed measuring face of micrometer?
- (A) Anvil
- (B) Barrel
- (C) Spindle
- (D) Thimble
12. Which part actuates the movement of the dial for reading measurement of dial bore gauge?
- (A) Stem
- (B) Plunger
- (C) Fixed anvil
- (D) Centring
shoe
Next Tests:
Blogger Comment
Facebook Comment