Process and Equipments of Wood Working MCQ Test - Set 10 - ObjectiveBooks

Process and Equipments of Wood Working MCQ Test - Set 10

Practice Test: Question Set - 10


1. When using power saws, always wear eye protection.
    (A) True
    (B) False

2. The Occupational Outlook Handbook is a good source of information about jobs in demand.
    (A) True
    (B) False

3. Cordless drills have rechargeable batteries.
    (A) True
    (B) False

4. The size of the grains on a sheet of sandpaper is referred to as grit.
    (A) True
    (B) False

5. Rabbets cut in the back edge of a cabinet frame should be cut a bit deeper than the thickness of the panel to be inserted.
    (A) True
    (B) False

6. A rabbet-and-dado joint is used when increased strength and stiffness are required.
    (A) True
    (B) False

7. The rabbet for a picture frame should be about 3/8 inch wide.
    (A) True
    (B) False

8. A screw-mate counter bore creates a wood plug that can be used to cover the screw head after it is installed.
    (A) True
    (B) False

9. A respirator with a charcoal filter is not enough to protect your lungs from adhesive fumes.
    (A) True
    (B) False

10. When planing table legs, be sure each side of all four of the legs is of identical width.
    (A) True
    (B) False

11. Basically, a bevel is any angle, including a right angle.
    (A) True
    (B) False

12. Do not attempt to cut cylindrical (round) stock on the table saw.
    (A) True
    (B) False

13. Make short cuts before long cuts on the band saw.
    (A) True
    (B) False

14. The sliding compound miter saw is pulled, rather than pushed, through materials clamped to its table; this is a safety factor.
    (A) True
    (B) False

15. Slower speeds make it easier to cut metals and plastics.
    (A) True
    (B) False

16. Always use a drill bit with a square shank.
    (A) True
    (B) False

17. Some sander discs rotate clockwise; others rotate counterclockwise.
    (A) True
    (B) False

18. The split ends on flagged bristles should be snipped off.
    (A) True
    (B) False

19. Use pumice mixed with linseed oil for the final rubbing of a varnished surface.
    (A) True
    (B) False

20. Air seasoning of wood may take from six months to five years.
    (A) True
    (B) False

21. Material Safety Data Sheets are required by OSHA for all hazardous materials kept in a shop.
    (A) True
    (B) False

22. Ripsaws are used to cut stock to width.
    (A) True
    (B) False

23. When nailing hardwood, drill starter holes and apply a little glue to the nail.
    (A) True
    (B) False

24. Edge butt joints are often used to make tabletops from narrow boards.
    (A) True
    (B) False

25. Technically, a dado is cut across the grain; a groove is cut with the grain.
    (A) True
    (B) False

Show and hide multiple DIV using JavaScript View All Answers

 Next Tests:

    Blogger Comment
    Facebook Comment
adplus-dvertising