Practice Test: Question Set - 01
1. Which stake is used for making sharp bends, folding the edges of sheet metal?
- (A) Funnel stake
- (B) Hatchet
stake
- (C) Beak iron
stake
- (D) Half moon
stake
2. What is the reason for sheet metal cutting is incorrect by using snips?
- (A) Cooling is
ineffective
- (B) Opening
angle incorrect
- (C) Selection of
snip incorrect
- (D) Full length
of blade by single stroke
3. What is called the developing lines and curves that form a pattern?
- (A) Stretch out
- (B) Pattern
- (C) Layout
- (D) Template
4. Which tool is used to level the sheet on a levelling plate?
- (A) Anvil
- (B) Stake
- (C) Mallet
- (D) Hammer
5. Which tool is used to punch small holes near the edge of thin sheet?
- (A) Nail punch
- (B) Prick punch
- (C) Centre punch
- (D) Hand lever
punch
6. What is the purpose of creasing iron stake grooving slots?
- (A) Making large
diameter thin gauge tubes
- (B) Making small
diameter thin gauge tubes
- (C) Making large
diameter heavy gauge tubes
- (D) Making small
diameter heavy gauge tubes
7. Which material is used for making mallets?
- (A) Brass
- (B) Copper
- (C) Hard wood
- (D) Aluminium
8. What is the supporting tool used in sheet metal work to bend, seam and form?
- (A) Anvils
- (B) Work bench
- (C) Bench vice
- (D) Wooden
formers
9. How to prevent the wing compass from slipping while scribing circles on sheet metal?
- (A) Make large
drill
- (B) Make small
punch mark to seat the compass leg point
- (C) Make small drill
- (D) Make small
boring
10. What is the advantage of half moon stake?
- (A) Squaring
corners
- (B) Shaping and
seaming funnels
- (C) Folding the
edges of sheet metal
- (D) Turning up
flanges on metal disc
11. What is called a piece of material cut to the exact size and shape to form desired object?
- (A) Pattern
- (B) Layout
- (C) Template
- (D) Stretch out
12. What is the name of striking portion of hammer?
- (A) Face
- (B) Pein
- (C) Cheek
- (D) Handle
13. What is the advantage of funnel stake?
- (A) Used to flat
edges
- (B) Used to
taper articles
- (C) Used to turn
circular disc
- (D) Used to
squaring corners
14. Which tool is used for producing holes in thin section material?
- (A) Drill
- (B) Anvil
- (C) Punch
- (D) Scriber
15. Which type of development method is applied if the other three methods cannot be developed?
- (A) Geometric
construction method
- (B) Triangulation
method
- (C) Parallel
line method
- (D) Radial line
method
16. Which instrument is used for measurement transfer to the wing compass?
- (A) Steel rule
- (B) Folding rule
- (C) Zigzag rule
- (D) Collapsible
rule
17. What development method applied for articles of components that are tapered to an apex?
- (A) Parallel
line method
- (B) Triangular
method
- (C) Radial line
method
- (D) Geometric
construction method
Blogger Comment
Facebook Comment