Tool and Cutter Grinding MCQ - ITI Machinist - Set 02 - ObjectiveBooks
Tool and Cutter Grinding MCQ - ITI Machinist - Set 02

Tool and Cutter Grinding MCQ - ITI Machinist - Set 02

,

Practice Test: Question Set - 02

1. What is the remedy to remove the black and shining face of grinding wheel?
    (A) Changing of wheel
    (B) Truing of wheel
    (C) Dressing of wheel
    (D) Balancing of wheel
2. Which is the shape of grinding wheel used for sharpening milling cutter and reamer?
    (A) Disc
    (B) Straight cup
    (C) Flaring cup
    (D) Dish
3. Which tool is used to form the radius on grinding wheel for radius grinding attachment?
    (A) H.S.S single point tool
    (B) Brazed single point tool
    (C) Diamond stick
    (D) H.C.S tool
4. Which part is used to support each individual tooth of cutter in correct position on tool and cutter grinder?
    (A) Compound rest
    (B) Steady rest
    (C) Tool rest
    (D) Tooth rest
5. What is the angular setting limit of an angular sine vice used in tool and cutter grinder?
    (A) Up to 27°
    (B) Up to 55°
    (C) Up to 80°
    (D) Up to 120°
6. Which material is used to make the base of tool and cutter grinding machine?
    (A) Grey cast iron
    (B) Low carbon steel
    (C) Tool steel
    (D) Bronze
7. Which attachment is used for grinding face mill up to 400mm dia?
    (A) Universal vice
    (B) Motor drive arrangement
    (C) Face mill grinding attachment
    (D) Angular sine vice
8. What is the use of radius wheel turning attachment in tool and cutter grinder?
    (A) Dress the wheel to the required radius up to 25 mm
    (B) Turn the work piece to any required shape
    (C) Turn the work piece to a radius up to 12 mm
    (D) Dress the wheel to any required shape
9. Which attachment is designed for grinding the land of a tap?
    (A) Radius wheel turning attachment
    (B) Angular sine vice
    (C) Tap relieving and sharpening attachment
    (D) Milling attachment
10. What is the maximum swiveling angle of wheel head on a tool cutter grind machine?
    (A) 360°
    (B) 120°
    (C) 90°
    (D) 47°
11. What is the use of work holding device?
    (A) Keep the work piece in a safe distance
    (B) Keep the cutter in a safe distance
    (C) Keep the work piece in position
    (D) Keep the cutter in position
12. What happened if tool little clearance is provided on milling cutter?
    (A) Chattering produced
    (B) No heat produced
    (C) Good surface finish
    (D) Bad surface finish
13. Which attachment is designed for holding work to any desired compound angle?
    (A) Universal vice
    (B) Angular sine vice
    (C) Positive indexing attachment
    (D) Motor drive arrangement
Show and hide multiple DIV using JavaScript View All Answers
 Next Tests:

    Blogger Comment
    Facebook Comment