Wood Engineering Carpentry Works Mock Test - Set 09 - ObjectiveBooks
Wood Engineering Carpentry Works Mock Test - Set 09

Wood Engineering Carpentry Works Mock Test - Set 09

Practice Test: Question Set - 09

1. Which of the following is not a helper used to feed stock into a tool?
    (A) Push stick
    (B) Feather board
    (C) Push block
    (D) Straightedge
2. Dowel centers are
    (A) Small metal pins used for marking
    (B) The wooden cores of dowel rods
    (C) Pieces of dowel rod used to strengthen joints
    (D) None of the above
3. Built-in _______ allow you to lock a power miter saw into position at a variety of angles.
    (A) Metal clips
    (B) Angle irons
    (C) Index plates
    (D) None of the above
4. A sheet of veneer is usually ______ inch thick.
    (A) 1/32
    (B) 1/28
    (C) 1/16
    (D) 1/8
5. When crosscutting, adjust the depth of cut so the teeth of the blade are about _______ inch below the table surface.
    (A) 1/16
    (B) 1/8
    (C) 1/4
    (D) 3/8
6. The scroll saw is also called a
    (A) Compass saw
    (B) Jigsaw
    (C) Coping saw
    (D) Band saw
7. To install a router bit, insert the shank of the bit as far as possible, then pull it out about ______ inch.
    (A) 1/8
    (B) 1/4
    (C) 3/8
    (D) 1/2
8. Which is not true for finish turning?
    (A) The tool used is a skew
    (B) Either cutting or scraping methods may be used
    (C) Work is begun at the center of the workpiece
    (D) None of the above
9. Create a wash coat of one part _______ to seven parts alcohol.
    (A) Linseed oil
    (B) Varnish
    (C) Lacquer
    (D) Shellac
10. If a chemical splashes into someone’s eye, the person should rinse the eye with
    (A) Alcohol
    (B) A gentle stream of cool water
    (C) Mercurochrome
    (D) Cold tea
11. The width of the cut made for a rabbet joint is determined by the
    (A) Size of the saw blade
    (B) Desired strength of the joint
    (C) Size of the project
    (D) Thickness of the stock
12. The ends of the socket piece in a dovetail joint are called
    (A) Pins
    (B) Half-pins
    (C) Tails
    (D) Blind ends
13. A typical dado head has two outside blades that are each _______ inch thick.
    (A) 1/16
    (B) 1/8
    (C) 1/4
    (D) 3/8
14. Rough turning is begun using a
    (A) Gouge
    (B) Round-nose
    (C) Spindle
    (D) None of the above
15. If the pattern for your workpiece includes loose curves, choose a _______ blade.
    (A) Thin, narrow
    (B) Long
    (C) Wide, thick
    (D) Saber
Show and hide multiple DIV using JavaScript View All Answers
 Next Tests:

    Blogger Comment
    Facebook Comment