Practice Test: Question Set - 04
1. Which part is used for turning stand base, fruit bowls in wood turning lathe?
- (A) Cup chuck
- (B) Face plate
- (C) Cup centre
- (D) Dead centre
2. Which part is adjusted according to the thickness of stock for sawing in band saw?
- (A) Guide post
- (B) Saw guides
- (C) Throat plate
- (D) Thrust
wheels
3. Which is the adjustment for height of saw guide post above the job in band saw machine?
- (A) 10 mm
- (B) 20 mm
- (C) 30 mm
- (D) 40 mm
4. How to maintain the band saw wheels before switching on the machine?
- (A) Clean the
rust
- (B) Clean the
dust
- (C) Check the
alignment
- (D) Guards must
be closed
5. What is the PPE to protect against inhaling of dust while working in planning machine?
- (A) Nose mask
- (B) Head shield
- (C) Leather
apron
- (D) Helmets
6. What is the cause for planed surface not straight and accurate?
- (A) Used proper
lubrication
- (B) Work piece
very hardness
- (C) Setting the
fence not properly
- (D) Rear table
not proper alignment
7. Which material is used in manufacture of horizontal bed in wood turning lathe?
- (A) Big iron
- (B) Cast iron
- (C) Drop forged
steel
- (D) High utensil
steel
8. Which type of wood is suitable for sanding work?
- (A) Old wood
- (B) New wood
- (C) Nailed wood
- (D) Excess glue
wood
9. How to maintain the wood turning job before setting the centers in wood working lathe?
- (A) Remove the
stone
- (B) Remove the
rough end
- (C) Remove the
rough surface
- (D) Remove the sharp
corners
10. Which part is tilted and lowered at an angle 45 Degree in band saw machine?
- (A) Table
- (B) Upper guide
- (C) Lower wheel
- (D) Upper wheel
11. How to avoid wobbling and twisting in the cut of band saw machine?
- (A) Using throat
plate
- (B) Using upper
wheel
- (C) Using thrust
wheels
- (D) Using guide
post Jaws
12. Which PPE is used for eye protection while working in planning machine?
- (A) Face shield
- (B) Helmets
- (C) Leather leg
guards
- (D) Gum boots
Next Tests:
Blogger Comment
Facebook Comment