Wood Working Machines and Tools Multiple Choice Tests - Set 13 - ObjectiveBooks
Wood Working Machines and Tools Multiple Choice Tests - Set 13

Wood Working Machines and Tools Multiple Choice Tests - Set 13

Practice Test: Question Set - 13

1. When cutting a bead, begin by raising and twisting the handle of the skew until the toe just shears the wood.
    (A) True
    (B) False
2. Toxic woods include fir and maple.
    (A) True
    (B) False
3. When installing dowels for an end-to-face butt joint, drill the holes in the face pieces first.
    (A) True
    (B) False
4. Use a chisel to remove waste stock from cuts made for lap joints.
    (A) True
    (B) False
5. T-plates are used to strengthen shelves.
    (A) True
    (B) False
6. The over-arm can be rotated in a complete circle around the column.
    (A) True
    (B) False
7. Use a faster speed for large holes and a slower speed for small holes.
    (A) True
    (B) False
8. Water-based stain has less tendency to bleed into lacquer than oil-based stain.
    (A) True
    (B) False
9. The backsaw has a thick blade with coarse teeth.
    (A) True
    (B) False
10. To make dado joints more attractive on a bookcase, decorative cuts can be made on the front ends of the shelves.
    (A) True
    (B) False
11. Twin-threaded utility screws are preferred for fine hardwoods.
    (A) True
    (B) False
12. Move the stock as slowly as possible into the blade to prevent burning the wood.
    (A) True
    (B) False
13. Feeding a router into the workpiece too slowly will cause it to heat.
    (A) True
    (B) False
14. The set of a saw affects the width of the kerf.
    (A) True
    (B) False
15. Drill guides help drill perfectly aligned holes.
    (A) True
    (B) False
16. When cutting a rabbet by hand, lock the workpiece in a vise.
    (A) True
    (B) False
17. When making a finger-lap joint, making the fingers and notches the same width as the thickness of the stock provides the most glue area.
    (A) True
    (B) False
18. When designing a mortise-and-tenon joint, the length of the tenon depends on whether glue will be used or not.
    (A) True
    (B) False
19. A broken screw can be removed by drilling out the damaged area and gluing in a hardwood dowel of the proper size.
    (A) True
    (B) False
20. When face planing, set the jointer to make a fairly deep cut.
    (A) True
    (B) False
21. The guard must be removed from the jointer to cut a rabbet.
    (A) True
    (B) False
22. The table of the band saw can be tilted to do chamfering.
    (A) True
    (B) False
23. When installing a blade, be sure the teeth are pointing up.
    (A) True
    (B) False
24. Cutting Vs is done with a parting tool.
    (A) True
    (B) False
25. Mill marks are caused by a planer or jointer.
    (A) True
    (B) False
Show and hide multiple DIV using JavaScript View All Answers
 Next Tests: